After installing the IDSDM/vFlash card you could do the following:
1. Install the MicroSD cards.
N
OTE
:
Reinstall the MicroSD cards into the same slots based on the labels you had
marked on the cards during removal.
2. Follow the procedure listed in
After working inside your system
.
LOM riser card
Removing the LOM riser card
l
Follow the safety guidelines listed in
l
Follow the procedure listed in
Before working inside your system
.
l
If installed, remove the risers.
Follow the below steps to remove the LOM riser card:
1. Using a Phillips #2 screwdriver, loosen the screws that secure the LOM riser card to the
system board.
2. Release the two blue side plastic snaps holding the LOM riser card.
3. Hold the LOM riser card by the edges on either side, and lift to remove it from the
connector on the system board.
4. Slide the LOM riser card towards the front of the system until the Ethernet connectors or
the Small form-factor pluggable (SFP) are clear of the slot in the back of the system.
Installing and Removing System Components
LOM riser card
80
GigaVUE-FM Hardware Appliance Guide for GFM-HW1-FM010 and GFM-HW1-FM001-HW
