Telstra Commander i, Service Manual

Page: 140 / 195

Programming
Commander i System User Guide - Issue 2
09a Ring Mode - PSTN
The ring mode is allocated to each station, one for each of the available
PSTN lines. This operation is to be carried out for both Day and Night
modes of operation.
There are three possible settings:
1 Immediate Ring
2 Delayed Ring (10 seconds)
3 Ring Excluded
To Select Ring Mode (Day or Night):
•
Press [i] to enter programming mode.
•
Dial 04 to go to the Administration menu.
•
Press [i] to confirm.
•
Enter four digit Administration password
and press [i ].
If the password is incorrect, the Admin menu is displayed. Press [i]
and re-enter correct password or press [RLS] to exit.
•
Dial 09 to go to the Ring Mode option.
•
Press [i] to confirm.
The Ring Mode value for each of the possible twelve stations is
displayed for line 01
•
Dial 01 - 04 to select the desired line number. Alternatively, scroll up
or down the line numbers using the [*] and [#] keys.
•
Press [i] to confirm the location.
•
Enter the appropriate setting for the
twelve stations.
You must enter twelve values, even though you may not have twelve
stations. If any of the entered numbers is invalid, the original setting
for that station will be retained.
•
Press [i] once to confirm, twice to re-enter or [RLS] to cancel.
•
Repeat the above steps for the other available line numbers.
•
Press [RLS] four times to exit.
WARNING: Be careful to avoid ring disabling or delaying for all
stations for the same line.
10a Remote Report
This facility displays the date and time of the last remote maintenance
session. In addition, the number of remote maintenance sessions
performed to date is also displayed
To view the time and date of the last remote maintenance
session:
•
Press [i] to enter programming mode.
•
Dial 04 to go to the Administration menu.
•
Press [i] to confirm.
•
Enter four digit Administration password
and press [i ].
If the password is incorrect, the Admin menu is displayed. Press [i]
and re-enter correct password or press [RLS] to exit.
•
Dial 10 to go to the Remote Report
display.
The number of remote maintenance sessions is displayed.
After approximately three seconds the
display shows the time and date of the
last remote maintenance session.
01: Repertory
04: Admin
Pass:
01aSet Time: 16:24
09aRing Mode D
01:111111111111
>
>111112113333
01: Repertory
04: Admin
Pass:
01aSet Time: 16:24
10aRemoteReport 015
16/04 14:23
Page 6-18 Page 6-19