Telstra Commander i, Service Manual, Page: 139 / 195

Programming
Commander i System User Guide - Issue 2
•
Enter four digit administration password
and press [i].
If the password is incorrect, the Admin menu is displayed. Press [i]
and re-enter correct password or press [RLS] to exit.
•
Enter 06 to go to the Send Data option .
•
Press [i] to initiate the sending of the data.
It takes about 30-45 seconds to complete the process. Underscore
signs are shown on the Master display, indicating that the operation
is in progress. During this time, the system is frozen. At the
completion of the sending of data, ‘OK’ is displayed.
07a User Password Reset
To Reset The User Password To The Factory Default Setting:
•
Press [i] to enter programming mode.
•
Dial 04 to go to the Administration menu.
•
Press [i] to confirm.
•
Enter four digit administration password
and press [i].
If the password is incorrect, the Admin menu is displayed. Press [i]
and re-enter correct password or press [RLS] to exit.
•
Enter 07 to go to the User Password
Reset option.
•
Press [i] to confirm.
•
Enter keystation number to be reset (1- 8).
•
Press [i] to confirm.
•
Press [RLS] three times to exit.
08a Administration Password
To Set The Administration Password:
•
Press [i] to enter programming mode.
•
Dial 04 to go to the Administration menu.
•
Press [i] to confirm.
•
Enter four digit administration password
and press [i ].
If the password is incorrect, the Admin menu is displayed. Press [i]
and re-enter correct password or press [RLS] to exit.
•
Enter 08 to go to the Admin Password
option.
•
Press [i] to confirm.
•
Enter four digit password.
•
Press [i] to confirm.
•
Press [RLS] three times to exit.
01aSet Time: 16:24
06aSend data
Page 6-15
01: Repertory
04: Admin
Pass:
01aSet Time: 16:24
07aUser Pass. reset
>
01: Repertory
04: Admin
Pass:
01aSet Time: 16:24
08aAdmin Pass
>
Page 6-16 Page 6-17