Sedecal SPL-HF 2.0, Service Manual

Page: 113 / 222

Portable X-ray Units
Service Manual
SM-1076R2 103
11. Once the components in the Central Support have been replaced,
connect the GND wire previously removed from the HV Transformer
GND stud.
12. Assemble the Central Support to HV Transformer.
13. Assemble the Upper and Lower Covers.
14. Re-install the Collimator.
Collimator replacement will affect centering of Collimator
light. Screwing may modify position of Collimator and it
must be manually centered while tightening the Safety
Screws. It is recommended 5 turns to each screw, check
parallelism between the Collimator and Unit Chassis, correct
position if necessary and finally tighten each Safety Screw
with the same number of turns (one by one).
Once the Collimator is replaced, the Unit fully assembled and
ready for operation, perform the Adjustments described in
Section 4.
15. If applicable, assemble the DAP Rails and SID Guard attached to the
Collimator.