Sedecal SPL-HF 2.0, Service Manual

Page: 20 / 222

Portable X-ray Units
Service Manual
SM-1076R2
10
2.2.3 X-RAY TUBE SELECTION
1. Select Configuration menu C04 .
2. Enter sub-menu C4.1 (for Tube-1) or C4.2 (for Tube-2). The kVp Display
shows (C4.1 or C4.2) and mAs Display shows the Tube identifier.
3. To change the X-ray Tube ID (identifier, shown on the kVp Display for
seconds) press
“mAs Increase / Decrease” and set the ID shown on the
“Inspection Report” document of the Unit.
4. Press “Reset” push-button to save data. The Tube ID is momentarily
shown on the kVp Display and a beep sounds.
5. Press “Collimator Light” push-button to exit the sub-menus . The kVp
Display shows (C04).
Errors E07 or E08 appear when the Tube ID is a default value
(E07 for Tube 2 and E08 for Tube 1).
In case the HV Transformer has been replaced, request the
manufacturer the Tube identifier to be configured.
2.2.4 TIME CONFIGURATION FOR “PREP” AND COLLIMATOR LIGHT
1. Select configuration menu C05.
2. Enter sub-menu C5.1 for “ Prep ” Time Configuration. The kVp Display
shows (C5.1) and the mAs Display shows (Factory set at 30 seconds,
within this lapse of time
“Exp” button should be pressed, otherwise the
exposure will not be allowed).
3. Press “mAs Increase” or “mAs Decrease” to change Preparation Time .
Value Factory set at 30 (range from 10 to 50).
4. Press “Reset” push-button to save value.
5. Press “kVp Increase” to enter sub-menu C5.2 for Collimator Light Time.
The kVp Display shows (C5.2) and mAs shows (Factory set 30).
6. Press “mAs Increase” or “mAs Decrease” to change Collimator Light
Time . Value Factory set at 30 seconds (range from 10 to 50).
7. Press “Reset” push-button to save value.
8. Press “Collimator Light” push-button to exit sub-menus. The kVp Display
shows (C05).