Tel: 886.909 602 109 Email: [email protected]
19
Earphone port
The S5105D/E/F microwave analyzer is provided with a standard 3.5mm/3-line earphone port
for outputting the sound modulated via FM/AM/SSB. If the port is not connected to the earphone,
the sound is output via the speaker of the microwave analyzer; when it is connected to the
earphone, the sound output is switched from the speaker to the earphone automatically.
4
Display interface description
The typical screen display in the spectrum analyzer mode is shown in Figure 3-10, and the noise curve
is high or low as per the band division based on the spectrum.
Figure 3-10 Screen display zone in the spectrum analyzer mode
The information display zone of the S5105D/E/F microwave analyzer displays various settings for current
measurement and instrument status, which can be divided into 5 zones as per the position on the screen,
namely, the left information display zone, main display zone, submenu zone, system status bar, and
main menu zone.
Information display zone in the left
The zone locates at the left of the screen for displaying such information in the Vector network
analyzer mode as the start frequency, stop frequency, sweep time, sweep points and IF bandwidth for
current measurement, such information in the spectrum analyzer mode as the reference level,
attenuation, scale and type of detection for current measurement, such information in the antenna
test mode as the start frequency, stop frequency, sweep time, sweep points and IF bandwidth for
current measurement, such information in the power monitoring mode as the start frequency, stop
frequency, offset and relative measurement, such information in the vector voltage measurement
mode as current measurement type (reflection by default), measurement port (port1 by default) and
measurement format (dB by default), and such information in the USB Power Meter mode as zero
calibration, frequency, offset and relative measurement, all of which can be set with corresponding
parameters by clicking. The contents displayed vary with the measurement mode.
Main display zone
The main display zone displays the measurement results. The trace is displayed in coordinate grid
in the Vector network analyzer and antenna test modes. Scale values and mark information are
displayed in the left and upper right of the grid respectively. Measurement parameters are displayed
