Rohde & Schwarz DIB-500 R4.1, Installation And Operation Manual

Page: 123 / 142

Installation and Operation Manual 90DIB500IM02 – 5.2 123
DIB-500 R4.1 Commissioning
Function tests DIB-500 R4.1
5.9 Function tests DIB-500 R4.1
After all activities performed on the product, which may have effects on the product and/
or its components, the proper functionality of all installed network and hardware compo-
nents should be inspected. We recommend to log the results of the inspection.
In this case you have to perform the following checks:
| Checking operating statuses
| Checking voice channels
– Checking the voice channel (two carriers)
– Checking the voice channel (more than two carriers)
| Checking the installation site of the GPS antenna
5.9.1 Tools and aids
The tools and aids required for performing the function tests are listed below.
The following tools and aids are required for performing the function tests:
| Service computer set up appropriately, refer to the "Service Computer for ACCESS-
NET
®
-T“ requirements manual.
| Network management client NMC-511 FaultManager
| SMT (Service and Maintenance Tool) for TIB - including a serial adapter cable
5.9.2 Checking operating statuses
Proper functioning of the product and the incorporated network or hardware compo-
nents can be checked manually – provided indicators are available – on the corre-
sponding network or hardware component or via a connected network management
client NMC-511 FaultManager.
In addition, the operating statuses can be checked via the SMT (Service and Mainte-
nance Tool) hardware component.
The following procedures for checking operating statuses are available for the
DIB-500 R4.1:
| Checking operating statuses (via the NMC-511 FaultManager)
| Checking operating statuses (via the Service and Maintenance Tool, SMT)
| Checking operating statuses (via LEDs of the TIB)
| Checking operating statuses (via LEDs of the voltage supply unit) – optional (only
for VAC voltage supply)