Installation and Operation Manual 90DIB500IM02 – 5.2
101
DIB-500 R4.1
Commissioning
Mounting the top cover of the equipment rack
5.6 Mounting the top cover of the equipment rack
The top cover of the equipment rack must be mounted again for normal operation.
The following tools and aids are required for removing and installing the top cover:
|
Phillips head screwdriver size PH2
|
Coin to unscrew/tighten the fastening screws of the equipment cabinet top cover
The procedure for mounting the equipment rack top cover is described in the following.
Proceed as follows to mount the top cover of the equipment cabinet:
Preparation:
✓
The equipment rack must be accessible from above.
✓
The tools and aids must be available, refer to section 5.1.1 on page 79.
✓
You need the fastening screws you removed before.
Carry out the following steps:
1. Position the equipment rack top cover.
2. Tighten the fastening screws of the equipment rack top cover. Use a coin to do so,
3. Fasten the mounting screws of the equipment rack grommet again. Use the size
PH2 Phillips head screwdriver for this purpose, refer to Figure 4.4.
✓
You have successfully mounted the equipment rack top cover.
5.7 Configuring the DIB-500 R4.1
The following chapter describes the procedure for properly setting up (configuring) the
product at its installation site.
Prerequisite for configuring the network element (as a preparatory measure for the net-
work-specific configuration of the network with the aid of the NMC-515 Configuration-
Manager network management client) is the completed commissioning of the network
element at its intended installation site, refer to chapter 4 and 5 as of page 59.
The following procedures are required for this purpose:
|
– Switching on the voltage source
– Switching on the equipment rack
– Connecting the service computer
|
|
Configuring and generating network configurations via the NMC-515 Configuration-
Manager
|
Creating the download repository
|
Adapting the IP address (with more than one TIB module)
|
Performing an initial download via NMC-522 DownloadManager
|
Setting a cavity coupler to the TX frequency
– Setting the output power
– Measuring and checking the carriers (impedance adjustment)
