DIB-500 R4.1
Safety regulations
Safety measures
20
Installation and Operation Manual 90DIB500IM02 – 5.2
2.3.1
Authorised personnel
The product may be transported, set up, connected, commissioned, operated and serv-
iced only by specialists who are familiar with and comply with the applicable safety reg-
ulations and setup instructions.
The specialists must be authorized to perform the required tasks by the person respon-
sible for the safety in the enterprise of the operator.
Specialists are persons, who:
|
are trained and experienced in the corresponding field
|
are familiar with the relevant standards, regulations, provisions and safety codes,
and
|
have been instructed in the mode of operation and the operating conditions of the
equipment components
|
can identify and avert hazards
Depending on the tasks to be performed, the following user groups are distinguished:
|
operators, who
– operate the product.
– monitor, interrupt, terminate and restore the operation of the product.
|
Service personnel: persons, who perform the following additional tasks as com-
pared to operators
– Set up the product.
– Prepare and restore the operational state.
– Adjust and/or parameterize the product.
– Maintain, look after and repair the product.
Replacing Network and Hardware Components
The replacement of components inside the component cabinet other than network or
hardware noted here must be performed exclusively by service personnel of Rohde &
Schwarz Professional Mobile Radio GmbH or by qualified personnel especially trained
for this job. If you have any questions on this topic, please revert to your responsible
service representative.
2.3.2
Electromagnetic compatibility
With specific products, e.g. HF radio equipment, increased electromagnetic radiation
may occur as a consequence of operation. Taking into consideration that unborn life is
increasingly worthy of being protected, pregnant women should be protected through
appropriate measures. People with personal medical devices such as cardiac pacemak-
ers and hearing aids can also be endangered by electromagnetic radiation. The opera-
tor is obliged to assess operation rooms with a considerable risk of exposure to
radiation and to avert any hazards.
In proper state and when operated properly, the product complies with all the require-
ments in respect of interference radiation according to ETSI EN 301 489-18. The con-
nections conducting HF signals must neither be manipulated nor damaged.
When using the product with active typical transmitters, the requirements of EN 50385
in respect of the health and safety of a user or any other person in high-frequency fields
are met. Compliance with EN 50385 is achieved as of a minimum distance of 1.5 m to
