DIB-500 R4.1
Commissioning
Configuring the DIB-500 R4.1
110
Installation and Operation Manual 90DIB500IM02 – 5.2
Command "ifconfig.xxx"
The "ifconfig.xxx" command opens the corresponding "ethX/Y" configuration file. "xxx"
corresponds to the respective configuration file. The "ethX/Y" configuration files depend
on the component. Thus, the commands listed below are possible:
|
MPU-550 and TIB/TOB (DIB-500 R3.2 and DIB-500 R4)
– eth1/1
– eth1/0
|
GPP-100 and TIB (DIB-500 R4.1)
– eth0/0
– eth0/1
8. Enter the following command to open the corresponding configuration file:
vi /etc/sysconfig/network/devices/ifconfig.xxx
"xxx“ corresponds to the command for the corresponding component.
➥
The "ethX/Y" configuration file will open. The following output is an example:
# ====================================================
# ACCESSNET-T Configuration File
#
# Network : cta
# Description : CTA_CFG_TL47_5_v04
# Config. Int. Version : 1.3
# Network Element : bs02-001
# Network Component : IntelPC_1
# Configuration version : 0.0
# Generated by : NMC-515 ConfigurationManager 2.32.7
# Date/Time : 2008-02-22 16:45:19
# =====================================================
ONBOOT=YES
SERVICE=ipv4-static
IP=10.255.25x.xxx
PREFIX=27
Depending on the component/s, multiple "ethX/Y" configuration files may be
available. The configuration file must match the corresponding component.
➔
Check the contents of the open configuration file. The "IP" entry must match the cor-
responding component, refer to 5.7.4 on page 107.
9. In the "IP“ entry, navigate to the passage to be adapted.
10. Enter the following command to delete the corresponding line:
x
11. Enter the following command to insert a corresponding figure:
i
