DIB-500 R4.1
Commissioning
Setting a cavity coupler to the TX frequency
118
Installation and Operation Manual 90DIB500IM02 – 5.2
7. Enter
the
p 1 -A sbue sbcc 02 0x
command to check the configured output
power of the corresponding carrier;
x corresponds to carrier no.
➥
The power of the corresponding carrier is displayed in mW:
BSC Command Shell tobs-ppc (Port: 5100)
u
'puc_1'-BSC 10.32.36.17 (5100) >u **
Password OK
User Level: 3
Command is okay
p l -A sbue sbcc 02 01
'puc_1'-BSC 10.32.36.17(5100)>pl-A sbue sbcc 02 01
Appl Node No In Description
Parameter value R
------------------------------------------------------SBUE SBCC 02
01 Transmit power of the carrier in mW 600
Command is okay
8. Repeat this work step for all the carriers that have to be set accordingly.
9. Enter the command
p s sbue sbcc 02 0x 25000
to set the output power to
25 W;
x corresponds to carrier no.
➥
The following output is displayed:
'puc_1'-BSC 10.32.36.17 (5100) >p s sbue sbcc 02 01 25000
SBUE SBCC 02 01 Transmit power of the carrier in mW 25000
Command is okay
10. Repeat this work step for all the carriers that have to be set accordingly.
11. Enter the command
car hw-reset x
to enable the transmitting power you previ-
ously set on the carrier,
x corresponds to carrier no.
➥
The following output is displayed:
'puc_1'-BSC 10.32.36.17 (5100) >
car hw-reset 1
'puc_1'-BSC 10.32.36.17 (5100) >car hw-reset 1
Command is okay
12. Enter the
bsca la
command to check whether the corresponding carriers have
really been enabled again.
➥
The following output is displayed:
bsca la
'puc_1'-BSC 10.32.36.17 (5100) >bsca la
Active Alarms of component BSC:
--------------------------------
none
Active Alarms of component CAR1:
--------------------------------
none
Active Alarms of component CAR2:
--------------------------------
none
Command is okay
