82
S
E
CT
ION 3
Se
tting
Me
asu
reme
nt Ite
m
s
Z550
Operation Manual
SECTION 3
Setting Measurement Conditions (Expert Menu)
The measurement line setting screen for the first point
appears.
If [Reflectance] is specified as the detection
method, the screens shown in
4.
to
9.
do not
appear.The measurement is made at the edge
level specified in [Reflectance correct/Edge
level].
p.64
4.
Specify the start and end lines.
Left/Right key: Moves the cursor.
(Press these keys together with the SHIFT Key to move
the cursor quickly.)
ENT Key: Selects the setting.
ESC Key: Cancels the setting.
The edge level setting screen for the first point appears.
5.
Align the dotted line with the edge to be detected.
Up/Down key: Moves the cursor.
(Press these keys together with the SHIFT Key to move
the cursor quickly.)
6.
Press the ENT Key to select the setting.
The selections appear.
7.
Select the edge search direction.
Points that can be detected at the specified edge level are
displayed as measurement point candidates.
8.
Keep pressing the Left or Right key until the cross
cursor appears at the edge to be detected.
In some cases, the cursor will not be displayed on
the intersection point of the edge level and the
edge position. However, selection of an arbitrary
cursor will give the same measurement result (the
intersection point becomes the measurement
point), as long as the selected cursor exists near
the intersection point.
9.
Press the ENT Key to select the setting.
Left
䇭㸢䇭
Right
Right
䇭㸢䇭
Left
operation.book Page 82 Monday, June 6, 2005 10:19 AM