84
S
E
CT
ION 3
Se
tting
Me
asu
reme
nt Ite
m
s
Z550
Operation Manual
SECTION 3
Setting Measurement Conditions (Expert Menu)
Edge Center
The center position between two edges can be measured.
The following conditions will be used as an example for describing the setting procedures.
1.
Select [Meas set].
A list of outputs appears.
2.
Select an output for which [Edge center] is set.
In this example, select [OUT1].
The selections for measurement item appear.
3.
Select [Edge center].
The operations from here are the same as
4.
to
11.
for the width measurement.
p.81
Edge level
Edge center
Scn 0
䂯䇭
Set
䂯
Image
Detect set
Meas set
Extra set
Meas mode
Output
Scn 0
䂯䇭
Set
䂯
OUT0:Height
OUT1:
OUT2:
OUT3:
OUT4:
OUT5:
OUT6:
OUT7:
Measrmnt item
Height
Step: 2 pts
Step: 3 pts
Edge position
Width
Edge center
Peak/bottom
Angle
operation.book Page 84 Monday, June 6, 2005 10:19 AM