![background image](http://html.mh-extra.com/html/omron/z550/z550_operation-manual_1633335040.webp)
38
SE
CTION 2
Le
ar
nin
g
B
a
sic O
p
er
ation
s
(C
on
ver
sa
tion
al M
e
n
u
)
Z550
Operation Manual
SECTION 2
Basic Operations
Step
5
Setting Workpiece Position Detection Method
Use the detection function if it is anticipated that the position of the workpiece may be shifted.
This function supports shifts in the position in the height and horizontal directions, and the inclination.
Example: Measuring the gap between two locations
Low
High
Height
Sensor
Scn 0
䂯
Run
䂯
Measurement target lines
Scn 0
䂯
Run
䂯
Scn 0
䂯
Run
䂯
Accurate measurement cannot be performed.
The measurement target lines are automatically adjusted by
the amount of shift detected, and the measurement is performed.
Measurement target lines
No position shift
(the same position
as at the setting)
When the position shifts
By setting position compensation...
operation.book Page 38 Monday, June 6, 2005 10:19 AM