![background image](http://html.mh-extra.com/html/omron/z550/z550_operation-manual_1633335033.webp)
31
Z550
Operation Manual
SE
CTION 2
Sc
reen
Type
s a
nd Dis
p
la
y M
e
tho
d
s
SECTION 2
Basic Operations
Trend Monitor
It is possible to display a time series of measurement values (up to 30 seconds) as a waveform.
When the measurement timing is entered using an external trigger, the measurement values are
displayed as a time series from the time the trigger is turned on until it is turned off.
Press the TRIG Key to switch between display update and stop.It is also possible to specify the
timing via an external trigger.
If the hold function has been set to [Hold (External)] or [Hold (Self)], the waveform prior to when the
measurement is held is displayed.
If the logging function has been specified, the waveform after the measurement is held is displayed.
S+
㸠
/
㸢
:Display S+ENT:Adjust
PASS
mm
+005.188000
Zero's OFF
Scn 0
䂯
99.60ms
OUT 0
䂯
Run
䂯
Thru
1div T: 0.996 [s]
V:0.1250[mm]
Screen Mode
Thru: The waveform obtained by the Sensor is displayed continuously.
Trig: A still image of the waveform based on the trigger settings is displayed.
Thin lines are used to represent the measurement start and
measurement end timings.
Output number
The current output number is displayed.
Force-zero
Zero's OFF: Force-zero not executed
Zero's ON: Force-zero executed
Trigger waveform
The trigger status is displayed.
Waveform display status
During waveform display,
(green) is displayed.
While the waveform is stopped,
(red) is displayed.
The units corresponding to 1 division (1 div) on the
waveform display are displayed. If the setting is
changed, the display also changes. Use these
values as reference when displaying the waveform.
Conversion values for X and Y axes
Measurement
value
Judgment result
1div
V:Measurement value(mm)
T:Second(s)
operation.book Page 31 Monday, June 6, 2005 10:19 AM