14
S
E
CT
IO
N 1
O
p
erati
onal
Flow
Z550
Operation Manual
SECTION 1
Features
Operational Flow
Preparation
for inspection
Turn the power supply on.
An error message is displayed
on the screen.
Select the measurement items
Select the measurement items
according to the purpose.
according to the purpose.
Back up the data.
Save the inspection conditions.
Set conditions for each model.
Set the conditions for
the system environment.
Set communication specification
and input/output format
with external devices.
Height Step: 2 pts
Step: 3 pts Edge position
Width Edge center
Peak/bottom
Angle
Area
Arithmetic average roughness
Maximum roughness
Define
Troubleshooting
Use the force-zero function.
Start up the Controller.
Start up the Controller.
Start up the Controller
Controller and display the profile.
Select the installation status
Select the installation status
of the sensor.
of the sensor.
Select the measurement range.
Select the measurement range.
Set the detection method of the
Set the detection method of the
workpiece position as necessary.
workpiece position as necessary.
Adjust the sensitivity.
Adjust the sensitivity.
Check the line beam
position
Set the measurement region.
Set the measurement region.
Clear measurement items.
Change the screen display.
Change the settings of
measurement items.
Screen types and display methods
Screen types and display methods
Set the measurement items.
Set the measurement items.
Start measurements.
Start measurements.
Initialize the
.
Measurement
execution
From setting conditions to execution
To learn about the basic flow from setting
To learn about the basic flow from setting
the conditions to executing the measurement
the conditions to executing the measurement
p.18
p.25
p.32
p.32
p.34
p.36
p.37
(p.56 Expert Menus)
p.43
(p.48 Expert Menus)
(p.50 Expert Menus)
(p.51 Expert Menus)
p.70
p.38
p.40
operation.book Page 14 Monday, June 6, 2005 10:19 AM