Getting Started FLUOVIEW/
Outline of LSM Observation Procedures
IV.
OPERATION INSTRUCTIONS
IV
. 1 - 5 4
Page
1-2-17 Turning Power Off
1. Turn off the power supply to the units (reflected light power supply, power outlet unit).
2. Turn the laser power OFF.
•
Ar laser, Multiline Ar laser:
Turn the key to the OFF position. The fan of laser head will stop automatically in
a few minutes, i.e. when the laser has cooled down.
Then set the power switch to OFF.
The fan of laser supply will stop.
(Refer to the instruction manual of your laser unit.)
•
Kr
laser:
Turn the key to the OFF position then set the power switch to OFF. The fan will
stop automatically in a few minutes, i.e. when the laser has cooled down.
(Refer to the instruction manual of your laser unit.)
•
HeNe (Green / Red) laser:
Turn the key to the OFF position.
•
HeCd
laser:
1.
Turn the <OFF> button of remote interface module OFF.
Wait till “LASER OFF” message appears on digital display. (For about 5
minutes to cool it down.)
2.
Turn the key switch of remote interface module to the OFF position.
3.
Turn the key switch of laser controller to the OFF position.
4.
Turn the rocker switch of laser controller to “0” (OFF).
Turning the laser power off by force may damage the laser
tube.
Never omit the step 1 (the process for cooling down) except
for emergency.
•
LD405/440
laser
1.
Set the shutter switch to CLOSE.
2.
Turn the key switch to the OFF position.
3.
Set the power switch to “O” (OFF).
NOTE
Summary of Contents for FLUOVIEW FV300
