Olympus FLUOVIEW FV300, User Manual

Page: 217 / 564

APPLIED OPERATIONS
/Image Acquisition
IV.
OPERATION INSTRUCTIONS
IV .
2 - 1 0 3
Page
3. From the page tabs on the bottom right of the [Acquire] panel, select the [Time
Series] sub-panel. The panel as shown below appears.
Fig. 2-25 [Time Series] sub-panel
4. Set the interval time to “10” using the < > and < > buttons in the [Interval] text
box. Change the interval time corresponding to the specimen.
5. Set the number of scans to “30” using the < > and < > buttons in the [N] text box
in the [Time Series] sub-panel. Change the number of scans corresponding to the
specimen.
6. Confirm that the time for image acquisition is set to 5 minutes (or 300 seconds) in
the [Total Time] text box. The time for image acquisition differs according to the
interval and the number of scans.
6 Setting the TIME COURS E Software (optional)
Setting of the real time graph is required when you use the TIME COURSE software.
Refer to the “FV-TIEMPO TIME COURSE software User’s manual” for details of the
TIME COURSE software.
[Rest Time] text box
Shows the time after the end of an
image acquisition until the start of next
acquisition
[N] text box
Set the number of scans with the < >
and < > buttons. Key entry is also
acceptable.
Under text box, it displays max. number
of slices that can be acquired with use
of physical memory only available at
that time.
[Interval] text box
Set the interval with the < > and< >
buttons. Key entry is also acceptable.
[Total Time] text box
Shows the time required to complete image
acquisition
.