Olympus FLUOVIEW FV300, User Manual

Page: 421 / 564

APPLIED OPERATIONS
/Viewing 3D Image
IV.
OPERATION INSTRUCTIONS
IV .
2 - 3 0 7
Page
2-9-3 Building Stereo 3D Images
Images composed of multiple image slices acquired by varying the multiple sections
(XYZ observation) can be built into a pair of stereo 3D images. These images can be
viewed three-dimensionally by watching them with two eyes for a while.
The operation is similar with animation. Perform steps 1 to 10 in section 2-9-2,
“Animation”, then proceed to the following steps.
1. Check the [Stereo Pair] check box.
2. Click the <Begin Visualize> button to start building the images. When the building
completes, the built images are displayed in the [3D Animation] panel.
The status bar shows the progress of building processing.
During the building, the <Begin Visualize> button turns into the <Cancel
Visualize> button. Click the <Cancel Visualize> button if you want to
cancel the building.
3. The following buttons are displayed at the top of the [Display] panel.
These buttons can be used to switch the stereo 3D images between the Ch1-only
images, Ch2-only images, Ch3-only images and images overlaying multiple
channels. Select the channel(s) of interest.
4. Watch the two images with two eyes for a while. They will look as a single 3D
image.
<Cancel Visualize>
button
TIP
TIP
Stereo 3D images.