Mercedes-Benz S 320 CDI, Owner'S Manual, Page: 537 / 588

515
Practical advice
Flat tyre
1
Wheel wrench
왘
Take wheel wrench
1
out of the vehi-
cle tool kit.
왘
Loosen the wheel bolts on the wheel to
be changed by about one turn, but do
not unscrew them.
1
Jacking point
2
Jack
3
Crank
왘
Position jack
2
at jacking point
1
.
왘
Make sure that the base of the jack is
located directly under jacking point
1
.
왘
Turn crank
3
until the tyre is raised a
maximum of 3 cm from the ground.
1
Centring pin
왘
Undo the uppermost wheel bolt com-
pletely.
왘
In place of the wheel bolt, screw cen-
tring pin
1
from the vehicle tool kit
into the thread.
왘
Undo the remaining wheel bolts.
!
Do not place wheel bolts in sand or on a dirty
surface. This could cause damage to the bolt and
wheel hub threads.
왘
Remove the wheel.
G
Risk of accident
Position the jack only at one of the appropri-
ate jacking points.
If you do not position the jack correctly, the
vehicle can:
앫
slip off the jack
앫
injure you or others
앫
be damaged
P40.10-4524-31
P40.10-4527-31
P40.10-4100-31
P40.10.4528-31