Mercedes-Benz S 320 CDI, Owner'S Manual, Page: 166 / 588

144
Operating systems
COMAND navigation system* (introduction)
왘
To set the map orientation: select
“Navi” “Navi” “Map display” .
The map display list appears. A
R
dot
indicates the current setting.
왘
Select “North up” or “Heading up” .
왘
To exit the menu: slide
o m p
.
The map orientation changes accord-
ingly.
Setting special destination icons
You can set the special destinations you
wish to have displayed as icons on the
map. Special destinations are, for exam-
ple, filling stations, hotels, cinemas and
restaurants.
The following settings are possible:
앫
“Standard symbols” (icon display deter-
mined by the factory settings)
앫
“Personal symbols” (you can determine
the icons yourself)
앫
“No symbols”
왘
To set: select “Navi” “Navi” “Map
display” .
The map display list appears. A
R
dot
indicates the current setting.
왘
Select “Standard symbols” or “Personal
symbols” or “No symbols” .
If you select “Personal symbols” , the
list of special destinations appears.
왘
To switch the icon display on or
off: select the required special des-
tination.
This will show the icons if their dis-
play was previously switched off,
and hide them if their display was
previously switched on. If a tick is
shown, this indicates that the dis-
play is switched on. You can switch
on the icon displays for more than
one special destination.
i
The list shows all icons that are contained in
the digital map across all countries. However,
not all the special destinations are available in all
countries. Certain special destination icons may
not be displayed on the map, even if the icon dis-
play is switched on.
왘
To exit the menu: slide
o m p
.
Geo-coordinate display
Map with geo-coordinate display switched
on
1
Current height above mean sea level
2
Number of GPS satellites from which a
signal can currently be received
3
Coordinate display
i
There must be sufficient GPS reception for
displays
1
,
2
and
3
to be shown. Height dis-
play
1
may vary from the actual value, because
the navigation system uses the GPS signal for
the calculation.
P68.20-5346-31