MAC215986
323
Revision A
IMPORTANT:
When removing auger fingers, work from the outside inward. Make sure there is an equal number of fingers on both sides
of the auger when complete.
1.
Start the engine. For instructions, refer to the combine operator
’
s manual.
2.
Raise the reel fully.
3.
Shut down the engine, and remove the key from the ignition.
4.
Engage the reel safety props. For instructions, refer to
Engaging Reel Safety Props, page 33
.
1033135
A
A
B
Figure 4.97: Auger Access Hole Cover
5.
Locate the access cover closest to the finger to be removed.
Remove and retain bolts (A) and access cover (B).
1033303
B
D
C
A
Figure 4.98: Auger Finger
6.
Remove hairpin (A). Pull finger (B) out of finger holder (C).
7.
If the finger is broken, remove any remnants from
holder (C) and from inside the drum.