MAC215986
214
Revision A
1003581
Figure 3.313: New Holland Combine Display
1.
Select HEADER LATERAL FLOAT on the combine display, and
press ENTER.
2.
Use the up and down navigation keys to move between
options, and select INSTALLED.
1003582
Figure 3.314: New Holland Combine Display
3.
Select HEADER AUTOFLOAT, and press ENTER.
4.
Use the up and down navigation keys to move between
options, and select INSTALLED.
Calibrating Auto Header Height Control
–
New Holland CR/CX Series
The auto header height control (AHHC) sensor output must be calibrated for each combine, or the AHHC feature will not
work properly.
DANGER
Ensure that all bystanders have cleared the area.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator
’
s manual for the most up-to-date information.
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to
NOTE:
If the header float is set too light, it can prevent the calibration of the AHHC. You may need to set the float heavier for the
calibration procedure so header does not separate from the float module.
