MAC215986
67
Revision A
1004601
A
B
C
Figure 3.73: Float Module Underside
3.
Start engine, and lower the combine feeder house so that
float module arms (A) are aligned with header balance
channels (B).
4.
Drive slowly forward, maintaining alignment between float
module arms (A) and header balance channels (B).
5.
Keep float module arms (A) just under balance channels (B)
to ensure float module legs seat properly in the header
linkage supports at location (C).
IMPORTANT:
Keep hydraulic hoses clear to prevent damage when driving
into header.
6.
Continue forward until float module arms (A) contact stops
in balance channels (B).
1031997
A
B
C
D
Figure 3.74: Center-Link
7.
Adjust length of center-link (A) using the header angle
hydraulics to approximately align center-link eye (B) with
the hole in the header bracket.
8.
Shut down the engine, and remove the key from the
ignition.
9.
Remove lynch pin (C) and pull pin (D)partially out of the
bracket.
NOTE:
Be careful when pulling out the pin, there may be some
washers on the pin to remove excessive play from the
center-link when installed.
10. Remove the item used to prop up center-link (A).
ϭϬϯϵϮϬϰ
A
B
C
Figure 3.75: Center-Link
11. Align center-link eye with the hole in the bracket, place any
washers (A) removed from Step
, onto each side
of the center-link while reinserting pin.
NOTE:
There may be none, one, or two washers.
12. Secure pin (B) with lynch pin (C).
CAUTION
Always connect center-link before fully raising header.
WARNING
Ensure that all bystanders have cleared the area.
13. Start the engine.
14. Raise the float module while making sure the float module legs engage the header legs.
