MAC215986
152
Revision A
1034099
A
B
Figure 3.202: Flex Checker Cable Lock
–
Left Side
24. Remove flex checker cable (A) from flex checker cable
lock (B).
IMPORTANT:
The flex checker cable may be damaged if it is left in place.
25. Repeat the procedure on the opposite side.
1028898
A
B
B
Figure 3.203: Left Endsheet
26. Return multi-tool (B) to its storage position, and secure it
with hairpin (A).
27. Reinstall the linkage covers. For instructions, refer to
Installing Outboard Flex Linkage Covers, page 46
or
Installing Inboard Flex Linkage Covers, page 45
NOTE:
Adjustment to the main float may be required to maintain
good wing balance when operating in the field. For
instructions, refer to
Checking and Adjusting Header Float,
28. If the cutterbar is not straight when the wings are in lock
mode, then further adjustments are required. Contact your
MacDon Dealer.
3.9.5
Header Angle
Header angle is adjustable to accommodate different crop conditions and/or soil types and can be adjusted using the
center-link between the combine and the header.
Refer to
Adjusting Header Angle from Combine, page 154
for combine-specific adjustment details.
1024172
A
B
D
C
Figure 3.204: Header Angle
Header angle (A) is the angle between the header and the
ground.
The header angle controls distance (B) between the cutterbar
knife and the ground and is critical when cutting crop at
ground level.
Adjusting the header angle pivots the header at the point of
skid shoe/ground contact (C).
Guard angle (D) is the angle between the upper surface of the
cutterbar guards and the ground.
