MAC215986
373
Revision A
1019330
A
B
Figure 4.182: Feed Deck Pan Handle and Left Side Pan
Handle Latch
19. Close the feed deck by latching pan handle latch support (B)
to feed deck pan handle (A) at both sides of the feed deck.
ϭϬϯϴϰϵϴ
A
A
A
B
A
B
C
D
Figure 4.183: Draper Seal
20. Reinstall mid-filler (D) with one button head screw and
washer (C). Reinstall retainer (B) with five countersunk
screws (A). Repeat this step on the opposite side of the
feed deck.
4.10.2
Checking and Adjusting Feed Draper Tension
Proper tension is required for the feed draper not to slip or have tracking issues.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator
’
s seat, and always engage the safety props before going under the
machine for any reason.
NOTE:
Illustrations show the left side of the float module. The right side is opposite.
1.
Raise the header fully.
2.
Shut down the engine, and remove the key from the ignition.
3.
Engage the header safety props. Refer to the combine Operator
’
s Manual.
Checking feed draper tension:
4.
Ensure the draper guide (the rubber track on the underside of the draper) is properly engaged in the groove on the
drive roller and the idler roller is between the guides.
