MAC215986
416
Revision A
1032007
A
B
B
C
D
A
B
C
D
Figure 4.271: Draper Connector
9.
Wrap the draper over the drive roller, and attach the ends
of draper with tube connectors (B), screws (A) (with the
heads facing the center opening), and nuts.
NOTE:
The two short tube connectors are attached at the front
and rear of the draper.
10. Install bridge connector (D) using screws (C) and nuts at the
front end of the draper joint.
1032009
A
Figure 4.272: Draper Tensioner
–
Left Side Shown
11. Tighten the draper by turning adjuster bolt (A) clockwise.
For instructions, refer to
12. Disengage the reel and header safety props. For
instructions, refer to
Disengaging Reel Safety Props, page
.
DANGER
Ensure that all bystanders have cleared the area.
13. Start the engine, and lower the header and reel.
14. Run the machine to verify the draper tracks correctly. If
additional adjustment is necessary, refer to
Side Draper Tracking, page 404
.
