MAC215986
125
Revision A
ϭϬϯϴϯϬϲ
A
B
Figure 3.147: Height Indicator
–
Rear Left End
6.
Set ContourMax
™
wheel height indicator (A) to
number 2 (B).
ϭϬϯϴϯϭϬ
B
A
Figure 3.148: Float Setting Indicator
7.
Lower the header until the auto header height indicator (A)
is at number 2 (B).
8.
Shut down the engine, and remove the key from
the ignition.
ϭϬϯϴϯϮϮ
A
Figure 3.149: Float Setting Indicator
9.
At the center of the header, measure distance (A) from the
ground to the tip of the center guard and record the
measurement.
10. At each end of the header, measure the distance (A) from
the ground to the tip of the end guard and record both of
the measurements.
•
If the difference between the end measurements and
the center measurement is less than 25 mm (1 in.), no
adjustment is required.
•
If the difference between the end measurements and
the center measurement is greater than 25 mm (1 in.),
adjustment is required. Continue to the next step.
WARNING
Ensure that all bystanders have cleared the area.
11. Start the engine.
12. Raise the header fully.
13. Engage the header
’
s safety props. For instructions, refer to
the combine operator
’
s manual.
