MAC215986
64
Revision A
1031950
A
B
C
Figure 3.65: Float Module Latch
13. Remove and retain screw (A).
14. Remove the M10 nut from bolt (B).
15. Use a 24 mm wrench on hex bolt (C) to rotate latch
downwards and slightly raise the feed deck to remove
bolt (B).
16. Rotate latch up and back to lower the float module deck
and disengage the transition pan tube.
17. Install screw (A).
18. Repeat for the opposite side of the feed draper deck.
DANGER
Ensure that all bystanders have cleared the area.
19. Disengage the reel safety props, start the engine, lower the reel, and fully raise the header.
20. Stop the engine, remove the key from the ignition, and engage the combine safety props.
1004592
A
B
Figure 3.66: Float Module Underside
21. Loosen nut and bolt (A), and disengage hook (B) from leg
on both sides of float module.
1004593
A
B
Figure 3.67: Float Module Underside
22. Rotate hook (B) 90° for storage, and retighten bolt (A)
and nut.
