MacDon CASE IH FlexDraper FD225, Manual

Page: 413 / 560

MAC215986
389
Revision A
1034189
A
Figure 4.220: Idler Roller Bearing
–
Left Side
18. After the bearing and both seals are seated around the
shaft, install nut (A) and torque it to 81 Nm (60 lbf·ft).
A B C
D E
ϭϬϯϴϯϵϬ
Figure 4.221: Idler Roller Bearing
–
Left Side
19. Rotate idler roller housing (A) until the holes in the lower
tabs aligns with the hole in welded tab (B).
20. Apply medium-strength threadlocker (Loctite ® 243 or
equivalent) to the bolt threads, and then insert the
following hardware at location (C).
•
Socket head bolt, washer, and nut.
21. Align the hole in cast support (D) with the holes in the
upper tab on idler roller housing (A).
22. Apply medium-strength threadlocker (Loctite ® 243 or
equivalent) to the bolt threads, and then insert the
following hardware at location (E).
•
Socket head bolt, washer, and nut.
23. Tighten bolts (C) and (E) to 12 Nm (9 lbf·ft).
IMPORTANT:
Do NOT fully tighten bolts (C) and (E).
24. Repeat Step 8, page 387 to Step 23, page 389 on the
opposite side.
ϭϬϯϴϯϵϭ
A
Figure 4.222: Feed Deck
–
Left Side
25. Fill the bearing cavity with grease, and install dust cap (A)
on both ends of the idler roller.
26. Check that the grease fitting is working.
27. Repeat Step 25, page 389 to Step 26, page 389 on the
opposite side.
28. Tension the feed draper. For instructions, refer to 4.10.2
Checking and Adjusting Feed Draper Tension, page 373 .
MAINTENANCE AND SERVICING