MAC215986
447
Revision A
1032034
A
D
B
C
E
Figure 4.342: Reel Endshields
–
Outboard Tail End
9.
Slightly lift the end of reel endshield (A) off of support (B).
10. Position new reel endshield (C) onto support (B) under
existing reel endshield (A).
11. Position the other end of new reel endshield (C) onto other
support (E) over the existing reel endshield.
12. Reinstall three bolts (D).
13. Reinstall the paddle (removed in Step
) onto the
new reel endshield if previously installed.
14. Tighten all hardware.
Replacing Reel Endshields at Inboard Tail End
The reel endshields need to be replaced if they are damaged.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
IMPORTANT:
Reel endshields are different for inboard and outboard tail end of header. For illustration, refer to
1.
Lower the reel fully.
2.
Lower the header fully.
3.
Shut down the engine, and remove the key from the ignition.
1031432
B
A
Figure 4.343: Reel Endshields
–
Inboard Tail End
4.
Rotate the reel manually until reel endshield requiring
replacement (A) is accessible.
5.
Remove six M10 screws (B) and nuts. Retain the hardware
for reinstallation.
