MAC215986
301
Revision A
4.6.3
Removing Driveline Guard
The main driveline guard must remain attached to the driveline during operation, but it can be removed for maintenance
purposes.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
NOTE:
The driveline does
NOT
need to be removed from the float module in order to remove the driveline guard.
1.
Shut down the combine, and remove the key from the ignition.
1020759
A
B
C
Figure 4.50: Combine End of Driveline
2.
Pull driveline collar (A) away from power take-off (PTO)
support (B). Slide yoke (C) off support (B), and release
collar (A).
1014179
A
B
Figure 4.51: Separated Driveline
3.
Lift the combine end of driveline (A) from the hook, and
extend the driveline until it separates. Hold the float
module end of driveline (B) to prevent it from dropping and
hitting the ground.
