MAC215986
449
Revision A
1031440
A
B
C
D
Figure 4.347: Reel Endshields
–
Inboard Tail End
13. Position tail end finger (A) as shown.
14. Secure tail end finger (A) and bushing (installed in Step
) with M10 bolt (B), end finger retainer (C), and
nut (D).
1031434
C
A
B
B
Figure 4.348: Reel Endshields
–
Inboard Tail End
15. Rotate reel endshield (A) upward and engage tabs (B) on
both ends.
16. Secure reel endshields using six M10 screws and nuts (C).
17. Torque nuts (C) to 35 Nm (26 lbf·ft). Do
NOT
overtighten
the nuts to prevent flattening of the tube.
Replacing Reel Endshield Supports
The reel endshield supports need to be replaced if they are damaged.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
NOTE:
All illustrations shown are from the outboard cam end.
1.
Lower the reel fully.
2.
Lower the header fully.
3.
Shut down the engine, and remove the key from the ignition.
