MAC215986
469
Revision A
F
A
B
H
G
H
D
C
E
J
ϭϬϯϵϬϭϲ
Figure 4.391: Mechanical Indicator
1.
Shut down the engine, and remove the key from the ignition.
2.
The mechanical indicator is zeroed when the notch in indicator (A) is aligned with hole (B) under the following
conditions:
•
Cable (C) is tight
•
Pin is installed in hole (D)
•
Cylinder (E) is fully retracted
3.
If the notch is not aligned with the hole under those conditions, adjust any or all of the following parts:
•
Loosen two nuts (H) and slide tube (J) up or down. Tighten the nuts.
•
Adjust cable jam nuts at locations (G) or (F). Tighten the cable jam nuts to 6 Nm (4 lbf·ft).