MAC215986
426
Revision A
1.
Start the engine.
2.
Lower the reel fully.
3.
Lower the header fully.
4.
Shut down the engine, and remove the key from the ignition.
1033235
A
B
Figure 4.290: Centering Reel
5.
Measure clearance (A) at locations (B) between the reel
tine tube and the endsheet at both ends of the header. The
clearances should be the same if the reel is centered.
1029257
A
B
C
Figure 4.291: Center Support Arm
6.
Loosen bolt (A) on brace (B) at the center support arm.
7.
Move the forward end of reel support arm (C) laterally as
required to center the reel.
8.
Tighten bolt (A) and torque to 457 Nm (337 lbf·ft).
4.13.4
Reel Fingers
If a reel finger is damaged or worn, it will need to be removed so it can be replaced. Reel fingers are either steel or plastic.
IMPORTANT:
Keep the reel fingers in good condition and straighten or replace them as necessary.
