MAC215986
428
Revision A
NOTE:
This procedure assumes a finger has been removed from the machine. For instructions about removing fingers, refer to
Removing Steel Fingers, page 427
1001286
A
B
Figure 4.293: Tine Tube
1.
Slide the new finger and tine tube arm (A) onto the end of
the tube.
2.
Install the tine tube bushings. For instructions, refer to
Installing Bushings onto Reels, page 435
.
3.
Attach the fingers to the tine tube with bolts and nuts (B).
Removing Plastic Fingers
Plastic reel fingers are secured to the tine tube with a single Torx® screw.
WARNING
To prevent bodily injury from the fall of a raised reel, always engage the reel safety props before going under the
raised reel for any reason.
1.
Lower the header fully.
2.
Raise the reel fully.
3.
Shut down the engine, and remove the key from the ignition.
4.
Engage the reel safety props. For instructions, refer to
Engaging Reel Safety Props, page 33
.
1001249
A
Figure 4.294: Removing Plastic Finger
5.
Remove screw (A) using a Torx
®
Plus 27 IP socket wrench.
