MAC215986
253
Revision A
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine,
remove the key, and engage the safety props before going under the header for any reason.
1.
Start the engine.
2.
Raise the header until the transport wheels are 51
–
102 mm (2
–
4 in.) off the ground.
NOTE:
Raise the header high enough that the cylinder safety props can be engaged
—
you will need to work under the
header to complete this procedure.
NOTE:
If engaging the safety props requires raising the header to a height where it is inconvenient to work on, use blocks
to support the header so that the transport wheels are 51
–
102 mm (2
–
4 in.) off the ground.
3.
Shut down the engine, and remove the key from the ignition.
4.
Engage the header
’
s safety props. For instructions, refer to the combine operator
’
s manual.
1034034
A
B
C
Figure 3.394: Right Transport Axle Latched in
Transport Position
5.
On the right transport axle, remove lynch pin (A) from the
right transport axle latch.
6.
Support the right transport axle using wheel handle (B),
then push handle (C) to release the right transport axle
from the header frame.
7.
Lower the right transport axle to the ground using wheel
handle (B).
8.
Reinstall lynch pin (A) into the latch.
1032252
A
Figure 3.395: Right Transport Axle Rotation
9.
Lift and rotate right transport axle (A) in the direction
shown using the wheel handle.
