MAC215986
117
Revision A
1028429
A
A
B
B
Figure 3.139: Feed Auger Float Adjustment
5.
Using a 21 mm wrench, loosen bolt (A) until the bolt head
is clear of bracket (B).
1028431
A
A
B
B
Figure 3.140: Feed Auger Float Adjustment
6.
Using a breaker bar in the square hole on arm (B), move
the arm forward until bolt (A) is in the slot on bracket next
to the fixed symbol.
NOTE:
If changing the auger position from fixed to floating, move
the arm in the opposite direction.
7.
Tighten bolt (A) to 122 Nm (90 lbf·ft).
IMPORTANT:
Bolt (A) must be properly seated in the recess on the
bracket before tightening the bolt. If arm (B) can be moved
after tightening the bolt, then bolt (A) is not seated
properly.
8.
Repeat on the opposite side.
IMPORTANT:
Bolt (A) on each side of the float module must be in the
same position to prevent damage to the machine during
operation.
