MAC215986
308
Revision A
4.7
Auger
The FM200 Float Module auger feeds the cut crop from the draper decks into the combine feeder house.
4.7.1
Adjusting Feed Auger to Pan Clearance
Operators should maintain an appropriate distance between the feed auger and the feed auger pan.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
IMPORTANT:
Maintain an appropriate distance between the feed auger and the feed auger pan. Too little clearance may result in the
fingers or flighting contacting and damaging the feed draper or pan when operating the header at certain angles. Look for
evidence of contact when greasing the float module.
1.
Extend the center-link to the steepest header angle (setting E), and position the header 254
–
356 mm (10
–
14 in.) off
the ground.
2.
Lock the header wings. For instructions, refer to
Locking/Unlocking Header Wings, page 140
3.
Shut down the engine, and remove the key from the ignition.
1029102
A
Figure 4.67: Down Stop Washer
4.
Check that the float lock linkage is on the down stops
(washer [A] cannot be rotated) at both locations.
