MAC215986
57
Revision A
1019711
A
B
Figure 3.47: Float Lock Handle
1.
Choose a level area and position the header slightly above
the ground.
2.
Stop the engine and remove the key from the ignition.
IMPORTANT:
If transport wheels are installed, the header may be
detached in either transport or field mode. If detaching
with the wheels in field mode, set the wheels to the
storage or uppermost working position, otherwise the
header may tilt forward, making reattachment difficult. For
instructions, refer to
IMPORTANT:
If stabilizer wheels are installed, set the wheels to the
storage or uppermost working position, otherwise the
header may tilt forward, making reattachment difficult. For
instructions, refer to
Adjusting Stabilizer Wheels, page 121
3.
Engage the float locks by pulling each float lock handle (A)
away from the float module and setting it in locked
position (B).
NOTE:
The illustration at the right shows the right side of the
header. The float lock on the left side of the header is
opposite.
1001472
A
Figure 3.48: Driveline
4.
Disconnect driveline from the combine. Push back collar on
the end of the driveline and pull the driveline out of
combine output shaft (A) until the collar disengages.
