MAC215986
213
Revision A
1003675
A
B
Figure 3.312: New Holland Combine Display
11. Select LEFT HEADER HEIGHT SEN (A), and then select
GRAPH button (B). The exact voltage appears at the top of
the page.
12. Raise and lower the header to see the full range of
voltage readings.
Header Settings Quick Reference
–
New Holland CR Series
Use the information in the following table to quickly reference the recommended settings for a FD2 Series FlexDraper
®
header..
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator
’
s manual for the most up-to-date information.
For detailed instructions, proceed to the New Holland CR series combine header setup and calibration procedures.
Table 3.31 Header Settings
–
New Holland CR Series
Setup Parameter
Suggested Setting
Cutting type
Platform
Header sub type
80/90
Autofloat
Installed
Auto header lift
Installed
Manual HHC raise/lower rate
Set for best performance
HHC height sensitivity
Set for best performance
HHC tilt sensitivity
Set for best performance
Reel height sensor
Yes
Setting up Auto Header Height Control
–
New Holland CR/CX Series
Auto header height control (AHHC) is set up using the combine display.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator
’
s manual for the most up-to-date information.
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to
