MAC215986
436
Revision A
1009854
A
B
C
Figure 4.312: Modified Channel Lock Pliers
1.
Use a pair of modified channel lock pliers (A) to install
bushing clamps (C). Secure pliers in a vise and grind a notch
(B) into the end of each arm to fit the clamp as shown.
Cam end bushings
1004616
A
B
Figure 4.313: Cam End
2.
Position bushing halves (B) on tine tube (A) with the
flangeless end adjacent to the tine tube arm, and position
the lug in each bushing half into the hole in the tine tube.
3.
Slide tine tube (A) towards the tail end of the reel to insert
bushing (B) into the tine tube arm. If the tine tube supports
are installed, ensure the bushings at those locations slide
into the support.
4.
Reinstall the previously removed fingers. Refer to the
following procedures as necessary:
•
Removing Plastic Fingers, page 428
•
Removing Steel Fingers, page 427
1001245
A
B
Figure 4.314: Bushing
5.
Install bushing clamp (A) onto the tine tube adjacent to the
flangeless end of bushing (B).
6.
Position clamp (A) on bushing (B) so the edges of the clamp
and bushing are flush when the clamp is fit into the groove
on the bushing and the lock tabs are engaged.
