MAC215986
143
Revision A
Operating in Flex Mode
The header is designed to operate with the cutterbar on the ground. The three sections move independently to follow the
ground contours. When the wings are unlocked, they are free to move up and down.
Unlock the wings as follows:
1031162
A
Figure 3.179: Wing in Unlocked Position
1.
Move spring handle (A) in the lower slot to unlock the wing.
You should hear the lock disengage.
2.
If the lock link does not disengage, move the wing by
raising and lowering the header, changing the header angle,
or driving the combine until it disengages.
3.
If the lock still does not disengage, continue to next step.
4.
Open the left endshield. For instructions, refer to
1028898
A
B
B
Figure 3.180: Left Endsheet
5.
Remove hairpin (A) securing the multi-tool to bracket on
the left endsheet.
6.
Remove multi-tool (B), and reinstall the hairpin onto the
bracket.
1034099
A
B
Figure 3.181: Flex Checker Cable Lock
–
Left Side
7.
Attach flex checker cable (A) to flex checker cable lock (B).
NOTE:
Parts have been removed from the illustration for clarity.
