MAC215986
372
Revision A
1028074
A
B
C
B
Figure 4.179: Float Module Feed Draper
13. Install the new draper over drive roller (A). Make sure the
draper guides fit into drive roller grooves (B).
14. Pull draper along bottom of feed deck and over idler
roller (C).
1012873
A
B
Figure 4.180: Draper Connector Straps
15. Connect the draper joint with connector straps (B) and
secure with nuts and screws (A). Ensure the screw heads
face towards the rear of the deck, and tighten only until the
end of the screws are flush with the nuts.
ϭϬϯϴϱϬϭ
B
A
Figure 4.181: Idler Roller Bearing Housing
16. Move the idler back to the operating position. Apply
medium-strength threadlocker (Loctite
®
243 or equivalent)
to bolt threads and reinstall the following hardware (A) to
secure idler roller casting (B) to the frame. Repeat this step
on the opposite side of the feed deck:
•
Socket head bolt, washer, and nut.
17. Tighten bolt (A) to 12 Nm (9 lbf·ft).
IMPORTANT:
Do
NOT
fully tighten bolt (A).
18. Adjust the draper tension. For instructions, refer to
