MAC215986
245
Revision A
3.14.3
Converting from Transport to Field Position (Option)
The header needs to be converted back to field position if it was towed to a new location.
Moving Left Outboard Wheel From Transport to Working Position
–
ContourMax
™
Option
The left outboard wheel need to be repositioned to the working position after being in the transport position.
DANGER
To avoid bodily injury or death from unexpected startup or fall of raised header, stop the engine, remove the key, and
engage the safety props before going under the header. If you are using a lifting device to support the header, be sure
that the header is secure before proceeding.
1.
Start the engine.
2.
Raise the header fully.
3.
Shut down the engine, and remove the key from the ignition.
4.
Engage the header safety props or support the header on blocks on level ground. If using blocks to support the header,
ensure the header is approximately 914 mm (36 in.) off the ground.
1034133
A
B
C
D
Figure 3.372: Left Wheel Assembly
5.
Remove lynch pin (A).
6.
Remove locking pin (B).
7.
Slide wheel assembly (C) out of storage bracket (D).
1034132
A
B
C
Figure 3.373: Left Wheel Assembly
8.
With the wheel facing inboard, align wheel assembly (C)
with the isolator assembly and slide it towards the front of
the header until the pin holes line up.
9.
Install locking pin (B).
10. Install lynch pin (A).
