MAC215986
296
Revision A
4.6
Header Drive
The header drive consists of a driveline from the combine to the FM200 Float Module gearbox that drives the feed auger
and hydraulic pumps. The pumps provide hydraulic power to the drapers, knives, and optional equipment.
4.6.1
Removing Driveline Connecting Float Module to Combine
The driveline transfers power from the combine PTO to the header float module completion gearbox. A quick release collar
allows the driveline to be removed when disconnecting the header float module from the combine.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Start the engine. For instructions, refer to the combine operator
’
s manual.
2.
Lower the reel fully.
3.
Lower the header fully.
4.
Shut down the engine, and remove the key from the ignition.
1034703
A
Figure 4.38: Driveline Shield
5.
Disconnect driveline safety chain (A) from the slot on the
aluminum plate.
1028483
B
A
Figure 4.39: Driveline Shield
6.
Pry clips (A) up to release shield (B).
