MAC215986
223
Revision A
1016055
A
B
Figure 3.330: New Holland Combine Display
11. Select GRAPH (A). The exact voltage (B) is displayed at the
top of the page.
12. Raise and lower the header to see the full range of
voltage readings.
Setting up Auto Header Height Control
–
New Holland CR Series
Auto header height control (AHHC) is set up using the combine display and control handle.
For best performance of the auto header height control (AHHC), perform these procedures with the center-link set to
D
.
When setup and calibration are complete, adjust the center-link back to desired header angle.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator
’
s manual for the most up-to-date information.
NOTE:
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other pre-2015 New
Holland combine models, refer to
1.
Ensure the center-link is set to
D
.
2.
Shut down the engine.
3.
Turn the key to the run position.
1016056
A
Figure 3.331: New Holland Combine Display
4.
Select TOOLBOX (A) on the main page. The TOOLBOX page
appears.
