MAC215986
385
Revision A
1034189
A
Figure 4.210: Feed Deck
–
Left Side
11. After the bearing and both seals are seated around the
shaft, install nut (A) and torque it to 81 Nm (60 lbf·ft).
12. Repeat Step
to Step
on the
opposite side.
A
B
C
D
E
ϭϬϯϴϯϵϬ
Figure 4.211: Idler Roller Bearing
–
Left Side
13. Rotate idler roller housing (A) until the holes in the lower
tabs aligns with the hole in welded tab (B).
14. Apply medium-strength threadlocker (Loctite
®
243 or
equivalent) to the bolt threads, and then insert the
following hardware at location (C).
•
Socket head bolt, washer, and nut.
15. Align the hole in cast support (D) with the holes in the
upper tab on idler roller housing (A).
16. Apply medium-strength threadlocker (Loctite
®
243 or
equivalent) to the bolt threads, and then insert the
following hardware at location (E).
•
Socket head bolt, washer, and nut.
17. Tighten bolts (C) and (E) to 12 Nm (9 lbf·ft).
IMPORTANT:
Do
NOT
fully tighten bolts (C) and (E).
18. Repeat Step
to Step
on the
opposite side.
ϭϬϯϴϯϵϭ
A
Figure 4.212: Feed Deck
–
Left Side
19. Fill the bearing cavity with grease, and install dust cap (A)
on both ends of the idler roller. Repeat this step on the
opposite side.
20. Check that the grease fittings on both sides are working.
Grease the feed draper idler roller bearing until grease
comes out of the seal. Wipe any excess grease from area
after greasing.
