MAC215986
407
Revision A
1020530
A
Figure 4.250: Header on Blocks
2.
Lower the header onto four blocks (A) (305
–
356 mm
[12
–
14 in.]). One block at each end and one block at each
hinge point.
3.
Shut down the engine, and remove the key from
the ignition.
4.
Engage the reel safety props. For instructions, refer to
Engaging Reel Safety Props, page 33
.
5.
Engage the header
’
s safety props. For instructions, refer to
the combine operator
’
s manual.
1032009
A
Figure 4.251: Tensioner
–
Left Side Shown
6.
Loosen the draper by turning adjuster bolt (A)
counterclockwise until the adjuster bolt runs out of
adjustment and hits a hard stop.
1032007
A
B
B
C
D
A
B
C
D
Figure 4.252: Draper Connectors
7.
Remove screws (C), bridge connector (D), and nuts from the
front end of the draper joint.
8.
Remove nuts and screws (A) and tube connectors (B) from
the draper joint.
9.
Pull the draper off the idler roller.
