1-34
Use the
undo storm-constrain enable log
command to disable log sending.
By default, log sending is enabled.
Examples
# Disable log sending for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo storm-constrain enable log
storm-constrain enable trap
Syntax
storm-constrain enable
trap
undo storm-constrain enable
trap
View
Ethernet port view
Default Level
2: System level
Parameters
None
Description
Use the
storm-constrain enable trap
command to enable trap message sending. With trap message
sending enabled, the system sends trap messages when traffic reaching a port exceeds the
corresponding threshold or the traffic drops down below the lower threshold after exceeding the upper
threshold.
Use the
undo storm-constrain enable trap
command to disable trap message sending.
By default, trap message sending is enabled.
Examples
# Disable trap message sending for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo storm-constrain enable trap
storm-constrain interval
Syntax
storm-constrain interval
seconds
undo storm-constrain interval
View
System view
Summary of Contents for E4510-48G
